This article shows you how to add the products controlled by a control unit (KLC 410) with a potential-free switch in order to finalise the setup of your new VELUX Touch.

Prepare your product(s) to be added to your new VELUX Touch.
IMPORTANT: If the control unit is only used with a potential-free switch, wall switch KLI must first be added to enable the VELUX Touch integration.

Control unit KLC 410 paired with wall switch (KLI 31x)

Follow the instructions: Copy from an existing wall switch (KLI 31x)

Control unit KLC 410 paired with control pad (KLR 200)

Follow the instructions: Copy from an existing control pad (KLR 200)

Control unit KLC 410 only used with a potential-free switch

Locate your control unit and the reset button (red dot marking on the cable side).
Press and hold the reset button for 10 seconds to reset all previous pairings.
Pair wall switch KLI with the control unit: On wall switch KLI, press the pairing button (icon with two circles) briefly using a pointed object.
Bring the control unit into pairing mode: On wall switch KLI, press the settings button (gear icon) briefly using a pointed object.
Add the potential-free switch: Press the open/up or down/close button on the potential-free switch.

Now return to your VELUX Touch to complete the product transfer and installation. Follow the instructions: Copy from an existing wall switch (KLI 31x)

Copy the products from a control unit (KLC 410) to VELUX Touch